TUTORIAL CFD-STUDIO

SQUARE CAVITY - NATURAL CONVECTION

Post-Processor
View 3D

If you have a 3D video board you probably enabled the 3D window and have followed the whole simulation process. If you don't, you can’t enable the window, but you can see the results after the simulation in the 3D window by clicking in the Post Processor window and in View 3D, as shown in Figure 57:


Figure 57 – CFD-Studio main console
It will appear a window like this:



Figure 58 – Console of the Post-processor
Images Manipulation:

Clicking and holding in the two buttons of the mouse and going forward you will decrease the zoom and going back you will increase the zoom (Figure 59).



Figure 59 – Zoom of the cavity

Clicking and holding only the right button you will move the picture down or up (Figure 60).



Figure 60 – Movement of the picture

Clicking only in the left button and moving the mouse you will rotate the image (Figure 61).



Figure 61 – Rotating the picture



Next Page
 
© SINMEC/EMC/UFSC, 2001. All rights reserved.